4W LED INTEGRATION TUBE LIGHT T5 0.3M 1FT 85-265V 328LM

Detailed parameters

Advantage

Energy saving: low power consumption,more than 60% of the energy-saving than traditional incandescent.
Green:Do not produce radiation, mercury and lead and hazardous substances, all components of the product recyclable, will not cause environmental pollution.
50,000 hours long life, more than 10 times that of traditional lamp life.
High-brightness light source: This product uses the highlighted SMD3014 light, every single lamp bead brightness of up to 82LM/W.
Drive technology: high efficiency, high low pressure isolated constant current drive power to raise the overall product performance.
The independent extrusion profile aluminum shell mold, concise and elegant appearance, the thermal structure of a scientific and rational. With the Optical Science, luminous uniform.
Use of safe, easy to install.

Replace traditional fluorescent wiring diagram

1.Please pay attention that when use Tube LED T8 to replace traditional fluorescent, you need to take away the starter, then you can install it into the bracket directly.

2.Removing ballast in the bracket saves much more energy.

3.Joining the cathode and anode power line to tubes at each side to light up, if you collect up two lines at one side, there will be a short circuit.

Notice for installation:

1.Before installation,cut off power to prevent electric shock,and avoid touching the surface of light while working.
2.The light should be avoid installed in place of heat,hot steam and corrosive gas,so as not to affect their working life.
3.Before installation,make sure that installation position can withstand 10 times the weight of the product.
4.For indoor use only,please pay attention to the waterproofing when using outside.
5.Please install on flat places with no vibration,no rocking and no fire hazard,pay attention to avoid dropping down,colliding and knocking.
6.Please pay attention that when use Tube LED T8 to replace traditional fluorescent,you need to take away the starter,then you can install it into the bracket directly.
7.Removing ballast in the bracket saves much more energy.
8.Jioning the cathode and anode power line to tubes at each side to light up,if you collect up two lines at one side, there will be a short circuit.